How do I manually operate my electric tarp if my motor should fail?
Remove the bolt that connects the motor to the tarp pipe, install crank handle to the rear tarp pipe at back end of trailer.
Does the suspension need to have the air dumped every time I unload?
The manufacturer always recommends dumping the air when the load is quickly unloaded potentially damaging the airbags by over filling. It is possible that when loads are slowly unloaded that the air exchange will be slow enough to prevent the over filling of the air bags.
Why does my ABS light come on when I hit my brakes?
Constant power is not being supplied to the ABS through the blue wire on your 7 way connector so every time you hit your brakes, the ABS system has to pull power off of your red wire (brake wire) and turns the system on and then it goes off when you let off the brakes. To correct this, make sure blue auxiliary wire is hot to trailer.
How do I adjust the trap doors?
Insert screwdrivers in between the top of the door and the bottom of the side trap frame member to wedge the dorr down. Push the spur gear cross shaft up against the rack and using the Timpte clearance gage (Part #035-38065) or a 7/64 drill bit for clearance, tighten down the fasteners. Remove the gage/drill bit and rotate the cross shaft with your hand. You will feel a backlash (movement to the shaft prior to engagement on the rack) and this is normal and correct. Remove the screwdriver wedges and run the door open and closed with your hand using the cross shaft. It should run smooth and easy.